1-2 Introduction and Specifications Date Code 20010731
SEL-352-1, -2 Instruction Manual
Section 5: Control Logic to understand inputs, the Relay Word, outputs, and logic. Use this
section to understand the settings necessary for implementing your logic.
Section 7: Setting the Relay to understand settings not described in Section 3 through Section 6,
for default settings, and for settings sheets.
Section 8: Serial Port Communications and Commands for a description of the serial port
commands used to set the relay for control, obtain target information, and obtain metering
information, etc.
Section 9: Front-Panel Interface for a description of how to perform the serial port commands
from the front panel.
Section 6: Metering and Monitoring to learn how to retrieve operations data such as metering,
dc battery monitor, breaker monitor, and relay status.
Section 10: Event Reports and SER for a description of event report and sequential events report
generation, event report formats, sequential event reports, and report interpretation.
Section 2: Installation to learn how to configure, install, and wire your relay.
Section 11: Testing and Troubleshooting for test procedures and a troubleshooting guide. You
can use this section as a tutorial to check your understanding of relay operation.
To Next Page
