Schweitzer Engineering Laboratories SEL-352-1 - TAR F N (Show Relay Word Targets on Front Panel)

8-40 Serial Port Communications and Commands Date Code 20010731
SEL-352-1, -2 Instruction Manual
The default row number can also be changed by the TAR F command, but each serial port has
independent defaults. The default row number returns to 0 when the port times out, the QUIT
command is executed, TAR 0 command is executed, or the TAR R command is executed.
The TARGET command does not remap the front-panel LEDs. See the TAR F command.
The following examples demonstrate the TARGET command:
=>> TAR<ENTER> Default Row is 0
EN PF 86BFT 86RS TRIP CLOSE 52A MOD
1 0 0 0 0 1 0 0
=>> TAR 8<ENTER> Display and Change Default to Row 8
25M 25C 46C 46B 46A 50MD 50LD 50FT
0 0 0 0 0 0 0 0
=>> TAR<ENTER> Default Row is 8
25M 25C 46C 46B 46A 50MD 50LD 50FT
1 1 0 0 0 0 1 0
=>> TAR 8 5<ENTER> Display Row 8 Five Times
25M 25C 46C 46B 46A 50MD 50LD 50FT
1 1 0 0 0 0 1 0
1 1 0 0 0 0 1 0
1 1 0 0 0 0 1 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
=>> TAR 37OPA X<ENTER> Display Row 9 (37OPA) But Do Not Change Default
Y47Q X47Q 37OPC 37OPB 37OPA 87HC 87HB 87HA
0 0 0 0 1 0 0 0
=>> TAR<ENTER>
25M 25C 46C 46B 46A 50MD 50LD 50FT
0 0 0 0 0 0 0 0
=>> TAR R<ENTER> Reset Default to Row 0
EN PF 86BFT 86RS TRIP CLOSE 52A MOD
1 0 0 0 0 0 0 0
=>>
Refer to Appendix F: Relay Word for a list of the Relay Word and the corresponding rows.
TAR F n (Show Relay Word Targets on Front Panel)
Access Level 1
The TARGET F command works like the TARGET command, but it also remaps the second
row of target LEDs on the front panel to follow the default row. The syntax of the TAR F
command follows:
TAR F n k X<ENTER>
 n specifies a new default Relay Word row by entering the number or the specific
Relay Word bit name. If n is not specified, the last default row is displayed.
 k specifies a repeat count for the command for the serial port display. The default is 1.
 X allows remapping the LEDs to a Relay Word row without changing the default row.