8-38 Serial Port Communications and Commands Date Code 20010731
SEL-352-1, -2 Instruction Manual
SHO T (Show Display Text Settings)
Access Level 1
View the front-panel Local Bit and Display Point settings using the SHO T command. The
Local Bit settings are NLBn (function name label), CLBn (“clear bit” label), SLBn (“set bit”
label), and PLBn (“pulse bit” label). The Display Point settings are DPn_1 and DPn_0, the text
displays for the two logic states of variable DPn. (Note: the DPn variables are viewed using the
standard SHO command.) See Section 9: Front-Panel Interface for more information on these
settings. The entire syntax of the SHO T command follows:
SHO T setting <ENTER>
setting specifies the setting name to immediately jump to. The default is the first setting.
Settings cannot be entered or modified with this command. Change settings with the SET T
command from Access Level 2 (SET command for DPn variables). The following example
shows the factory default text settings. Refer to Section 7: Setting the Relay for all default
settings and settings worksheets.
=>SHO T<ENTER>
Text Settings
NLB1 =MANUAL TRIP CLB1 =RETURN SLB1 = PLB1 =TRIP
NLB2 =MANUAL CLOSE CLB2 =RETURN SLB2 = PLB2 =CLOSE
NLB3 = CLB3 = SLB3 = PLB3 =
NLB4 = CLB4 = SLB4 = PLB4 =
NLB5 = CLB5 = SLB5 = PLB5 =
NLB6 = CLB6 = SLB6 = PLB6 =
NLB7 = CLB7 = SLB7 = PLB7 =
NLB8 = CLB8 = SLB8 = PLB8 =
NLB9 = CLB9 = SLB9 = PLB9 =
NLB10 = CLB10 = SLB10 = PLB10 =
NLB11 = CLB11 = SLB11 = PLB11 =
NLB11 = CLB11 = SLB11 = PLB11 =
NLB13 = CLB13 = SLB13 = PLB13 =
NLB14 = CLB14 = SLB14 = PLB14 =
NLB15 = CLB15 = SLB15 = PLB15 =
NLB16 = CLB16 = SLB16 = PLB16 =
DP1_1 =BREAKER CLOSED DP1_0 =BREAKER OPEN
DP2_1 = DP2_0 =
DP3_1 = DP3_0 =
DP4_1 = DP4_0 =
DP5_1 = DP5_0 =
DP6_1 = DP6_0 =
DP7_1 = DP7_0 =
DP8_1 = DP8_0 =
DP9_1 = DP9_0 =
DP10_1 = DP10_0 =
DP11_1 = DP11_0 =
DP12_1 = DP12_0 =
DP13_1 = DP13_0 =
DP14_1 = DP14_0 =
DP15_1 = DP15_0 =
DP16_1 = DP16_0 =
=>>
To Next Page
