Date Code 20010731 Manual Change Information i
SEL-352-1, -2 Instruction Manual
MANUAL CHANGE INFORMATION
The date code at the bottom of each page of this manual reflects the creation or revision date.
Date codes are changed only on pages that have been revised and any following pages affected
by the revisions (i.e., pagination). If significant revisions are made to a section, the date code on
all pages of the section will be changed to reflect the revision date.
Each time revisions are made, both the main table of contents and the affected individual section
table of contents are regenerated and the date code is changed to reflect the revision date.
Changes in this manual to date are summarized below (most recent revisions listed at top).
Revision
Date
Summary of Revisions
The Manual Change Information section has been created to begin a record of revisions to
this manual. All changes will be recorded in this Summary of Revisions table.
20010731 Reissued entire manual.
Corrected cross-references throughout to match section name changes and
reordered information.
Section 1: combined with previous Section 3: Specifications; changed name to
Section 1: Introduction and Specifications; removed information regarding
manual fonts, formatting, and objective reading.
Section 3: replaced and renamed to Section 3: Breaker Logic, which includes
Protection Logic and Breaker Alarm Logic from previous Section 4: Relay
Logic and all of previous Section 5: Breaker Failure Applications; reordered
and edited text; added discussion of setting UBLOG, added setting ranges.
Section 4: replaced and renamed to Section 4: Close Logic, which retains
Control Logic from previous Section 4: Relay Logic and all of previous Section
6: Control Relay Applications; reordered and edited text; added a number of
figures and modified others.
Section 5: replaced and renamed to Section 5: Control Logic, which contains
all but Protection Logic, Control Logic, Event Report Trigger, and Breaker
Alarm Logic subsections from previous Section 4: Relay Logic.
Section 6: moved to new Section 4: Close Logic; replaced and renamed to
Section 6: Metering and Monitoring, which contains Breaker Monitor Report,
Breaker Resistor Thermal Report, Metering Report, Status Report, and Relay
Word Bit Report subsections from previous Section 7: Data Recording
Application; dropped the word “Report” from these subsection titles and
changed subsection Status Report to Status Monitor.
To Next Page
Loading...
