EasyManua.ls Logo

Schweitzer Engineering Laboratories SEL-387E - Page 2

Schweitzer Engineering Laboratories SEL-387E
578 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
!
CAUTION: The relay contains devices sensitive
to electrostatic discharge (ESD). When working
on the relay with front or top cover removed,
work surfaces and personnel must be properly
grounded or equipment damage may result.
!
ATTENTION: Le relais contient des pièces
sensibles aux décharges électrostatiques (DES).
Quand on travaille sur le relais avec le panneau avant
ou du dessus enlevé, les surfaces de travail et le
personnel doivent être mis à la terre convenablement
pour éviter les dommages à l'équipement.
!
CAUTION: There is danger of explosion if the
battery is incorrectly replaced. Replace only with
Ray-O-Vac
®
no. BR2335 or equivalent
recommended by manufacturer. Dispose of used
batteries according to the manufacturer’s
instructions.
!
ATTENTION: Il y a un danger d’explosion si la
pile électrique n’est pas correctement remplacée.
Utiliser exclusivement Ray-O-Vac
®
No. BR2335 ou
un équivalent recommandé par le fabricant. Se
débarrasser des piles usagées suivant les instructions
du fabricant.
!
CAUTION: The continuous rating of the current
inputs is 3 · I
nom
. If any currents in this test will
exceed this rating, reduce the TAPn values as
needed, to prevent possible damage to the input
circuits.
!
ATTENTION: La capacité, en régime permanent,
des entrées de courant est 3 · I
nom
. Si un courant
d’essai dépassait cette valeur, réduire la prise TAPn
pour prévenir les dommages aux circuits d’entrée.
!
CAUTION: The continuous rating of the current
inputs is 3 · I
nom
. For this test, you may want to
choose low values of U87P and TAPn, in order to
limit the required test current to a safe value.
!
ATTENTION: La limite, en régime permanent, des
entrées de courant est 3 · I
nom
. Pour ce test, vous
pourriez choisir de valeurs peu élevées pour U87P et
TAPn, de façon à limiter le courant de test à une
valeur sécuritaire.
!
WARNING: This device is shipped with default
passwords. Default passwords should be changed
to private passwords at installation. Failure to
change each default password to a private
password may allow unauthorized access. SEL
shall not be responsible for any damage resulting
from unauthorized access.
!
AVERTISSEMENT: Cet équipement est expédié
avec des mots de passe par défaut. A l'installation,
les mots de passe par défaut devront être changés
pour des mots de passe confidentiels. Dans le cas
contraire, un accès non-autorisé à l'équipement
pourrait être possible. SEL décline toute
responsabilité pour tout dommage résultant de cet
accès non-autorisé.
!
DANGER: Removal of relay front panel exposes
circuitry which may cause electrical shock that
can result in injury or death.
!
DANGER: Le retrait du panneau avant expose à la
circuiterie qui pourrait être la source de chocs
électriques pouvant entraîner des blessures ou la
mort.
!
DANGER: Contact with instrument terminals
may cause electrical shock which can result in
injury or death.
!
DANGER: Le contact avec les bornes de l'
instrument peut causer un choc électrique pouvant
entraîner des blessures ou la mort.
© 2000–2008 by Schweitzer Engineering Laboratories, Inc. All rights reserved.
All brand or product names appearing in this document are the trademark or registered trademark of their respective holders. No SEL trademarks may
be used without written permission. SEL products appearing in this document may be covered by US and Foreign patents.
Schweitzer Engineering Laboratories, Inc. reserves all rights and benefits afforded under federal and international copyright and patent laws in its
products, including without limitation software, firmware, and documentation.
The information in this manual is provided for informational use only and is subject to change without notice. Schweitzer Engineering Laboratories, Inc.
has approved only the English language manual.
This product is covered by the standard SEL 10-year warranty. For warranty details, visit www.selinc.com or contact your customer service
representative. PM387E-01

Table of Contents

Related product manuals