Schweitzer Engineering Laboratories SEL-387E - CTARGET Command

Date Code 20080110 Compressed ASCII Commands E-9
SEL-387E Instruction Manual
CTARGET C OMMAND
Display the SEL-387E Relay Compressed ASCII target display by sending:
CTA N <Enter>
Where N is one of the target numbers or element names accepted by the TAR command. If N is
omitted, 0 is used.
The relay responds:
<STX>
"LLLL","LLLL","LLLL","LLLL","LLLL","LLLL","LLLL","LLLL","yyyy"<CR>
x,x,x,x,x,x,x,x,"yyyy"<CR>
<ETX>
where LLLL are the labels for the given target.
x is 0 or 1 corresponding to the first line labels.
yyyy is the 4-byte ASCII representation of the hex checksum for the line.