EasyManua.ls Logo

Sealife DC2000 - Before Entering Water; Entering;Exiting the Water; After Using the Housing Underwater; Installing Flash Link Optical Cable Adapter

Sealife DC2000
105 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
92
8) Makesuretherearenoobstructionsthatpreventhousingfromclosingorsealingproperly.Close
thehousingdoorbyattachingthelatchmechanismtothedoorandpushdownonthelatchuntil
lockingtab“clicks”intoplace.
9) Takeatestpicturetocheckthatthehousingshutterbuttonisactivatingtheinnercamerashutter
button.Also,rotatethemodedialtocheckthatthehousingandcameramodesareinsynch.
Before Entering Water
Mostdiveoperationswillhaveafreshwatertubusedexclusivelyforunderwatercameras.Usethis
tubtoperformaquickwaterproofleaktestbeforeenteringthewater.
1) Holdhousingunderwaterforabout15secondswiththelensaimingupwards.Liftthehousingout
ofthewaterkeepingthelenspointingupandlookatLCDdisplaywindowforanywaterdrops.
2) Ifnoleaksaredetected,holdthecameraunderwaterforabout2minutesandinspectforwater
drops.
Note:Ifyoudetectanyleaks,carefullydryandopenthehousingandinspecttheO-ringsealin
accordancewiththeinstructionsonpage94.
Entering/exiting the water
Important:Thetoppriorityistoalwaysobeydivesafetyrules.
1) Donotjumpintothewaterwiththecamerainyourhand.Havesomeonehandittoyouafteryou
haveenteredthewater.
2) Sameapplieswhenexitingthewater–handthecamerauptosomeoneandthenexitthewater.
3) Immediatelyplacethesealedhousinginfreshwater,soseawaterdropsdonotdryonthe
housing,whichmaycausewaterstainsand/orsaltcrystalstoform.
After using the housing underwater
• Soakandrinsethesealedwaterproofhousinginfreshwaterforabout2minutesafterunderwater
useorifthehousingbecomesdirty.
• Pusheachbuttonseveraltimesandrotatemodedialtocleanoutanytrappedsaltwater,sandor
dirt.
• Useclean,softclothtodryhousing.Makesurethatyouandthewaterproofhousingarecompletely
drybeforeopeningthewaterproofdoororchangingthebatteriesorthememorycard.
• Storecameraandhousingonlyaftercarefulcleaningandwhentotallydry.
• Keepthehousingunlatchedwhenstoringformorethan3months.
Installing Flash Link optical cable adapter
TheDC2000includesaFlashLinkadapterusedformakingopticalcableconnectionbetweenthe
underwaterhousingandoneortwoSeaDragonDigitalFlashes(optionalaccessory).TheSea
DragonFlashincludestheopticalcable.IfyouarenotusingaSeaDragonashaccessory,theFlash
Linkadapterisnotneeded.PleasecontactyourlocalauthorizedSeaLifedealerorrefertowww.
sealife-cameras.comformoreinformationabouttheSeaDragonFlashaccessory.

Table of Contents

Other manuals for Sealife DC2000

Related product manuals