Sealife DC2000 - How to Replace the Housing O-ring; Removing the O-ring

94
3) Pulltheotherendofthecameratoremovesomeoftheextraslack,leavingabout1”ofcable
bendasshownbelow.Itisnormalforthinlayerofcablesheathingtobescratchedoffduringthis
procedure.
4) AttachtheFlashLinkadapterontothetopofthediffuser(A).Thenpushdownonthebottomof
theadapter(B)untilitlocksintothediffuser.
Note:Abovediagramshowssideviewofadapterwithoutopticalcableforclearerdescription.
How to replace the housing O-ring
ReplaceO-ringorhavewaterproofhousingservicediftheO-ringorO-ringcontactsurfacesbecome
damaged.TheO-ringshouldbereplacedeveryyeartoensureproperseal.OnlyuseofcialSeaLife
O-ringdesignedfortheDC2000(Item#SL74017).ReplacementO-ringsareavailableatyourlocal
authorizedSeaLifedealer,oronlineatwww.sealifepartsdirect.com(USAOnly).
RemovingtheO-ring
Important:DonotusetoolsorsharpobjectstoremovetheO-ringtoavoiddamagingthesoft
siliconematerial.
1) PushtheO-ringalongitsgrooveuntilitlifts.Donotusetoolsorsharpobjectstoremovethe
O-ringtoavoiddamagingthesoftsiliconematerial.