| 4 - Instruction manual
Integrating the charger into a network without DHCP using Fixed
IP
If there is no DHCP server in the network and you are working with fixed IP addresses, please
observe the following information.
The charger is delivered with automatic IP assignment configured by default. After adding it
in the Sennheiser Control Cockpit, you can reconfigure it to Fixed IP. To do so, proceed as
described: Integrating the charger into a network without DHCP using Auto IP.
If you wish to do this, you must temporarily reconfigure the host PC on which the Sennheiser
Control Cockpit is installed to automatic IP assignment.
If the CHG 2N charger is visible in the Sennheiser Control Cockpit, you can do the IP
configuration manually:
▷ Change the IP settings under Device Details -> Network in the Sennheiser Control
Cockpit.
238
To Next Page
Loading...
