| 4 - Instruction manual
Connecting a pre-configured charger to the Sennheiser Control
Cockpit
If mDNS is activated (factory setting), the charger is automatically detected in the network.
If the charger has been reconfigured according to one of the procedures described above
and mDNS has been deactivated, you can add the charger manually using the Add Device
function in the Sennheiser Control Cockpit.
To add the charger in the Sennheiser Control Cockpit:
▷ Use the Add Device function in the Sennheiser Control Cockpit and enter the pre-
configured IP address.
239
To Next Page
Loading...
