EasyManuals Logo

Sensia JISKOOT InSpec Sampler User Manual

Sensia JISKOOT InSpec Sampler
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
InSpec Sampler Controller SECTION 2: COMMON SOFTWARE FEATURES
37
ALARM PHASE LOG
Allows you to navigate the directory structure and select a batch alarm phase log
(AL_PH.CSV). The alarm phase log from this folder could then be printed. You will be notified if
the alarm phase log file does not exist.
REGISTER LOG
The reglog csv file contains information on specific register changes. This acts as an
audit trail. In the event of any problems, a historical data trail will reveal what parameters were
altered prior to an issue arising. The Reglog.csv file contains the name of the user who was
logged in when the change was made, and each line of the file contains a terminating
checksum to validate the contents of each entry.
MODBUS LOG
The modlog csv file contains information on specific Modbus address changes. This
acts as an audit trail. As with the reglog file, this file provides a historical data trail for the
Modbus address data. The modlog.csv file contains the name of the user who was logged in
when the change was made, and each line of the file contains a terminating checksum to
validate the contents of each entry.
REBOOT LOG
This file records the number of reboots initiated by the software watchdog. This
comma separated file records the time and date of each reboot and, most importantly, which
application software task instigated the reboot. Ideally this file should never exist!
REPORT TEMPLATE
The report template file is a copy of the current report format. You may wish to email
this to someone who wishes to verify and/or edit the contents. The format of the report file is
highly configurable in the InSpec.
ALL SYSTEM FILES
This option will send all the InSpec configuration files to the specified recipient. This
facility is likely to be initiated on site by an engineer. The system files can be sent to a Jiskoot
engineer for analysis.
UCL PROGRAM FILE
If a UCL file exists it will be emailed. If not, a message will appear telling you that the
file does not exist.
CONFIG.TXT
The config.txt file is a file containing the entire contents of the registers and Modbus
address table. This is the same content generated by the CS command line.
CONFIG.MODBUS.CSV
This comma separated file contains a full listing of the current Modbus assigned data.
CONFIG.ALARM.CSV
This comma separated file contains a full listing of the current alarm configuration.
CONFIG.CAL
This simply contains the current values for the ADC and DAC registers. It is a
snapshot of the current IO status.
CONFIG.BIN
This binary file is a direct copy of the memory containing the register data.
AUTO REPORT MAIL
Here you set the configuration option to set if a batch report is automatically emailed
at the end of a batch.
AUTO LOG MAIL
Here you set the configuration option to set if a batch log is automatically emailed at
the end of a batch.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sensia JISKOOT InSpec Sampler and is the answer not in the manual?

Sensia JISKOOT InSpec Sampler Specifications

General IconGeneral
BrandSensia
ModelJISKOOT InSpec Sampler
CategoryController
LanguageEnglish

Related product manuals