InSpec Sampler Controller SECTION 7: INSITU PROGRAMMING
After the application is started you will see further information unique to the UPGRADE task as follows:
Erasing FRAM
Defaulting registers
........................................................
Loading registers and Modbus addresses from prior
version
........................................................
Upgrade completed
Enter username to access shell:
After the upgrade is completed the application will start and you will see the usual shell
username/password prompt.
7.3 Upgrading – The upgrade data folder.
After you upgrade the application you will notice that the process creates an upgrade folder on the SD
card system. The flash_app.one file that was created from a copy of the new software image is also deleted.
The contents of the Upgrade directory are as shown below:
M:\> CD UPGRADE
M:\UPGRADE\> DIR
Directory of M:\UPGRADE\*
. <DIR> 04.07.2018 12:07 [ ]
.. <DIR> 04.07.2018 12:07 [ ]
software_upgrade.fin 119,589 04.07.2018 12:09 [ ]
software_upgrade.MODBUS.CSV 25,200 04.07.2018 12:07 [ ]
software_upgrade.CALIBRATION.TXT 171 04.07.2018 12:07 [ ]
software_upgrade.BIN 65,536 04.07.2018 12:07 [ ]
software_upgrade.ALARMS.CSV 1,965 04.07.2018 12:07 [ ]
UPGRADE.LOG 0 04.07.2018 12:09 [ ]
8 File(s) 212,461 bytes
1,924,136,960 bytes free.
M:\UPGRADE\>
M:\> DIR
Directory of M:\*
SYSTEM <DIR> 29.01.2018 15:25 [ ]
2018 <DIR> 29.01.2018 16:01 [ ]
BACKUP <DIR> 29.01.2018 15:36 [ ]
UPGRADE <DIR> 04.07.2018 12:07 [ ]
4 File(s) 0 bytes
1,924,136,960 bytes free.
M:\>
To Next Page
Loading...
Need help?
General
