InSpec Sampler Controller
WARNING!
This instrument is designed for connection to hazardous electric voltages.
Ignoring this warning can result in severe personal injury or mechanical damage.
To avoid the risk of electric shock and fire, the safety instructions of this manual must be
observed and the guidelines followed.
The specifications must not be exceeded, and the unit must only be applied as described
in the following.
Prior to the installation and commissioning of the unit, this manual must be examined
carefully.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
HAZARDOUS
VOLTAGE
CAUTION!
WARNING!
Until the instrument is fixed, do not connect hazardous voltages to the instrument.
The following operations should only be carried out on a disconnected module and under
ESD-safe conditions: -
Dismantlement of the instrument for setting of dipswitches and jumpers.
General mounting, connection and disconnection of wires.
Troubleshooting the module.
REPAIR OF THE INSTRUMENT MUST ONLY BE DONE BY JISKOOT.
WARNING!
Installation may only be carried out by electrically skilled and instructed personnel in
accordance with national legislation, including the relevant standards.
All technical data on the instrument is to be observed.
Changes to the design and modifications to the equipment are not permitted.
The equipment shall only be operated as intended and only in undamaged and perfect
condition.
Sufficient segregation must exist between different cables and wires carrying different
types of signal or power and all other circuits.
All wires must be terminated, complete with crimping lugs. Unused cores should be
terminated to the earth bus bar.
To Next Page
Loading...
Need help?
General
