95
Troubleshooting
Unable to save the startup image
\ Do not turn off the projector while transmission.
The image data may be lost.
Quality of the image is low
\ Check the compression rate setting (page 81).
\ Note that Quick Transfer is fixed in the “Normal quality, middle speed”
setting.
Unable to speed up the transfer or improve the image quality
\ If the image file is saved in JPEG format, its compression rate cannot
be changed.
Note that the compression rate only applies to BMP file format.
Unable to speed up “Gamma Correction” though the
transmitting speed was changed
\ The transmitting speed setting applies to image transfer via cable
only. The speed for transfer of gamma values is fixed at 9,600 bps.
To Next Page
Loading...
