Important Information
FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH 15
Subject to change without notice
Compliance with the above requirements is the sole responsibility of the user.
NOTICE:
If the real gas temperature in the pipeline is higher than the ignition
temperature marked by the temperature code on the tag of the FLSE100, the
possible explosive atmosphere does not contain gases which are classified in a
temperature code with a lower ignition temperature than the highest gas
temperature respectively the outside surface temperature of the pipeline itself.
The possibility for heating up of the ambient air by the pipeline around that
must be observed. Ambient temperature around the electronic enclosure must
not exceed +70 °C for FLSE100 marked with T4 and must not exceed +55 °C
for FLSE100 marked with T6. The compliance with these requirements is the
sole responsibility of the user. Particularly the FLSE100 marked with
temperature code T6 run the risk of non-resettable switch-off due to the
thermal cutoffs inside the electronics enclosure. In this case the FLSE100
must be repaired by the manufacturer only. Warranty will be expired.
To Next Page
Loading...
Need help?
General
