Start-up and Parameter Settings
FLOWSIC100 Flare · Operating Instructions · 8013344/11L2/V 2-5/2018-10 · © SICK Engineering GmbH 181
Subject to change without notice
Stored parameters can be edited without a connected device and transferred back to
the device at a later time.
● Saving as a protocol
Device data and parameters are registered in the Parameter protocol.
A Diagnosis protocol can be created for analysis of the device function and recognition
of possible malfunctions.
Saving as a project
If connections are frequently established, it is advisable to save as a "Project". If connection
to the device is to be established again, only this "Project" must be opened. All files
previously saved are automatically transferred to SOPAS ET.
To save, select the respective device, call up the "Project / Save“ menu and specify target
directory and file name. The name of the file to be stored can be chosen freely. It is useful
to specify a name with a reference to the measuring point involved (name of the company,
equipment designation).
Fig. 116 "Project / Save" menu
See the Service Manual for a description.
To Next Page
Loading...
Need help?
General
