7
Cancel the sampling point program
8
Continue the sampling point program after "Pause"
9
Input: Number of sampling points
ß
Minimum measuring time per sampling point
à
Checkmark: Fixed cycle time 285 s (“DeSOx time”)
á
Checkmark: Fixed cycle time from "Cycle time"
â
Checkmark: Fixed sampling point time
ã
Input: Cycle time
DeSOx-Time (à)
The DeSOx-Time is based on Guideline MEPC.259(68). This requires that each measur‐
ing point must be measured once within 4:45 minutes (285 seconds).
To enter in the menu below: Subtract the hold times from the 4:45 minutes and divide
the remaining time by the number of measuring points. For example: For 2 measuring
points with the same hold time, each measuring point is active for 142 seconds.
This can be used, for example, to control the release of the measured value on Modbus.
Fix.Cycle-Time (á)
The“Fix.Cycle-Time” corresponds to the “DeSOx-Time”, however the cycle time is not
specified fixed but can be entered explicitly (see menu above).
Fix.Msp-Time (â)
Measuring on each measuring point continues for the time specified under “Duration”
in the menu.
This means different measuring times can be defined per measuring point. If the dura‐
tion set is shorter than the “hold time + minimum measuring time”, the duration is
automatically set to this time. The following is also valid - the total of “hold times + the
minimum measuring time” per measuring point may not be longer than the cycle time.
Otherwise the cycle time is increased accordingly.
Figure 75: Measuring point program - menu description
1
Sampling point index
2
Sampling point name
3
Sampling point sequence
4
Measuring time at the sampling point including run-in times
5
Run-in time
6
Checkmark active: Sampling point active
Figure 76: Measuring point program - setting options
1
Display: Sampling point index
2
Checkmark: Sampling point active
3
Sampling point name
4
Overall duration at the sampling point
6 PARAMETERIZATION
54
T E C H N I C A L I N F O R M A T I O N | MARSIC300 8017585/YXD9/V3-1/2017-05 | SICK
Subject to change without notice