Installation of Expansion and Option Module
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
4-25
For internal distribution only Installation
Installation Diagram
● On the HiPath 1130/1150
Installation Procedures
6. “Performing a Visual Inspection” on page 4-48.
7. Turn on the power supply.
8. Configure the required data (see “Operation” on page 6-1).
Figure 4-20 Installing a Fax/DID ModuleHiPath 1120
Step Procedure
1. Remove the power supply.
2. Remove the Main Distribution Frame’s cover.
3. Remove the backplane.
4. Remove the slots above the MB.
5. Attach the separator provided with the module to the MB.
6. Attach the module to the MB’s pin connector and to the separator.
7. Reassemble the entire set.
Step Procedure
To Next Page
Loading...
