Installation of Expansion and Option Modules
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-30 HiPath 1100, Service Manual
● On the HiPath 1130/1150
Procedure after Installation
Figure 4-25 Installing a Power Supply HiPath 1130/1150
Step Procedure
1. Check network voltage
2. If the voltage is within the power supply’s voltage range, connect the
power supply.
3. “Performing a Visual Inspection” on page 4-48
4. Configure the required data (see “Operation” on page 6-1).
Warning
To turn the power on or off to the system use the cable of the power supply.
!
To Next Page
Loading...
