Backplane
Modules For internal distribution only
A31003-K1250-S100-12-7619
3-48 HiPath 1100, Service Manual
3.9 Backplane
Introduction
In the HiPath1130/1150/1190 systems, a set of connectors mounted on a printed cir-
cuit board known as the backplane connects the modules to the motherboard.
● HiPath 1130/1150
Interfaces
Two identical backplanes are provided with the systems as shown in Figure A. In
some cases you may need to insert a ferrite bead into the backplane. If the module
came with a ferrite bead, install it as shown in Figures B and C.
Figure 3-32 Backplane HiPath 1130/1150
To Next Page
Loading...
