Connecting the System to the Power Suppl
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
6-1
For internal distribution only Operation
6 Operation
This chapter describes the procedures for powering up and initializing the systems.
This chapter covers the following topics:
6.1 Connecting the System to the Power Supply
Procedure
6.2 Updating the Software
If your computer already has a version of the HiPath 1100 software installed, you may
update it with the latest version.
The software update for version 5.2 uses version 5.1 update (from version 3.4) for up-
dating version 5.1 to version 5.2.
In the first window of the 5.2 software update you will be asked if you are updating
your software from version 5.1 to version 5.2. If so, the 5.1 software update will be
invoked by the APS and a message will be displayed indicating the conversion re-
quired for the database backup file.
To update to a more recent version than the one already provided, the process must
be repeated. On the second time the software update will run as it usually does (that
is, it will not call the 5.1 update), and you will be able to load the latest version.
To retrieve the database backup from 5.1 and update it to 5.2 you must use version
5.2 HiPath 1100 Manager.
Warning
Powering up and initializing the system is a task that must be performed only by au-
thorized technical personnel.
Step Action (Instructions)
1. Connecting the system to the power source
(Connecting the power cable ->Initializing the system).
page 6-1
2. Updating the Software. page 6-1
3. Starting the Programming Mode. page 6-2
Step Procedure
1. Complete installation of all modules (Chapter 4, “Installation”).
2. Plug in power cord
3. Wait a few moments for the system to load the software.
!
To Next Page
Loading...
