Installation of Expansion and Option Modules
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-22 HiPath 1100, Service Manual
4.6.2 Installing Modules
● On the HiPath 1120
Installation Procedures
● On the HiPath 1130/1150
Installation Procedures
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Insert the module into one of the slots shown in Figure 4-16.
4. Connect the module to the MOB using the flat cable on the top slot.
In the CND version, the EB module and the motherboard must be con-
nected using a power/connection cable.
5. To install on the bottom slot lift the top slot and use the pin connector to
make the connection.
6. Connect to module connectors (see Figure 4-27).
7. Reassemble the entire set.
8. “Performing a Visual Inspection” on page 4-48.
9. Turn on the power supply.
10. Configure the required data (see “Operation” on page 6-1).
Step Procedure
1. Remove the power supply.
2. Remove the backplane.
3. Insert the module into one of the slots shown in Figure 4-18.
4. Reassemble the entire set.
5. “Performing a Visual Inspection” on page 4-48.
6. Turn on the power supply.
7. Configure the required data (see “Operation” on page 6-1).
To Next Page
Loading...
