Siemens HiPath 1130 - Figure 4-23 Installing a Music Module Hipath 1120; Installing a Music Module

Installation of Expansion and Option Modules
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-28 HiPath 1100, Service Manual
4.6.7 Installing a Music Module
● On the HiPath 1120
Installation Procedures
Installation Diagram
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Raise the system’s top slot (MB).
4. Insert the module in the slot show on Figure 4-23.
5. Attach the MB to the module.
6. Make the connections to the appropriate module connector (see“Music
Module” on page 3-41).
7. Reassemble the entire set.
8. “Performing a Visual Inspection” on page 4-48.
9. Turn on the power supply.
10. Configure the required data (see “Operation” on page 6-1).
Figure 4-23 Installing a Music Module HiPath 1120