Installing an USB Interfac
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
4-39
For internal distribution only Installation
4.9 Installing an USB Interface
Introduction
To connect a PC to the HiPath 1100 using an USB interface you must have an USB
adapter cable (see“USB adapter cable” on page 3-54). This interface allows you to
use some applications developed specifically for configuring and managing user fea-
tures.
Connections
Step Procedure
1. Plug the USB adapter cable (with the male Mini DIN connector) into the
4-pin Mini DIN connector on the motherboard (Figure 4-31)
2. Connect the A to B Standard end of the USB cable to the USB adapter,
and connect the other end to the computer or modem.
3. See System Programming Mode in the“Programming with a Computer”
on page 6-3.
Figure 4-31 Illustration of USB cable connection
To Next Page
Loading...
