Comments about the System’s Programming Codes
Configuring the System Specifically for the Client For internal distribution only
A31003-K1250-S100-12-7619
7-44 HiPath 1100, Service Manual
Example:
When a call is transferred, a new CDR record is created. The Hold Time on an external
line is accounted for by the extension that transferred the call.
Ticket Cost Code (095)
External calls can be assigned Cost Codes which provide more control over telepho-
ny costs (see Functions Used During a Call - Cost Code, in the User Manual). This
information may be presented on the billing ticket.
Baud Rate (20)
This setting specifies the transmission rate between the system and a printer or a PC.
25-digit Suppression in CDR Record (21)
This setting specifies how many end digits can be omitted in the data output when
dialing a call on an external line. They will be replaced by the symbol "?."
Call Detail Report for Incoming Calls (61)
When this option is selected, call details are shown in the CDR record.
Call Detail Report Filter (67)
Specifies a unique sequence of 4 digits that will be recorded.
Call Detail Report with a Serial Interface (006)
This setting specifies that the Call Detail Report will be done through a serial inter-
face.
Table 7-22 CDR Header Layout
Date Time Ln Ext WCOS Ring Duration Number I Callfees Acc. code
22.11.99 14:00:00 01 21 00:14 00:01:34 2222222 1
For the system to receive Caller ID information over digital, E1 CAS or analog lines
the Caller ID feature must be enabled by the local carrier.
CommServer does not work when this setting is enabled.
To Next Page
Loading...
