Siemens HiPath 1130 - Installation of Expansion and Option Modules; Figure 4-16 Location of the Modules on the Hipath 1120; Modules Location

Installation of Expansion and Option Modules
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-16 HiPath 1100, Service Manual
4.6 Installation of Expansion and Option Modules
Installation Information
In the HiPath 1120 system the CPU and the modules are interconnected through a
flat cable and/or pin connector. In the HiPath1130/1150/1190 systems, the modules
are interconnected through the backplane connector.
Insert modules only when the power supply is turned OFF. For information on how
to expand your system, see“Limitations to System Expansion” on page 2-5.
4.6.1 Modules Location
● On the HiPath 1120
Figure 4-16 Location of the Modules on the HiPath 1120