Comments about the System’s Programming Codes
Configuring the System Specifically for the Client For internal distribution only
A31003-K1250-S100-12-7619
7-42 HiPath 1100, Service Manual
phone.
To execute the required programming proceed as if the remote telephone was
connected directly to the system.
Ending Remote Administration (96)
Ends remote configuration by means of a Standard MF telephone.
7.2.9 Entrance Telephone
Configuring an Entrance Telephone (15)
This function enables the system to use an entrance telephone.
Door Lock (16)
This feature detects when there is a locking device installed.
DIDs for Entrance Telephones (59)
Specifies the extensions that will be called when the Entrance Telephone is activat-
ed.
Permissions for the Door Opener (25)
Specifies the extensions that will be able to use the electric Door Opener.
7.2.10 Call Detail Recording
For better control over the calls, the system issues Call Detail Reports with informa-
tion about calls received and calls made. This information can be sent to a PC or print-
er via serial interface connection. To generate reports that can help control costs, the
Call Detail Report feature must be installed on the PC.
The following information is recorded:
● Current date (Date)
● End of call (Time)
If the system is connected through a serial cable to a PC with access to the tele-
phone system, the programming can also be done using a modem in conjunction
with the HiPath 1100 Manager. Refer to the instructions provided in the Help file.
To provide accurate call details, you must update the system’s time and date infor-
mation.
To Next Page
Loading...
