Installing an External Audio Source
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-40 HiPath 1100, Service Manual
4.10 Installing an External Audio Source
The HiPath 1100 systems provide connections for audio devices, such as radios, tun-
ers, CD, MD, and others.
● HiPath 1120
The audio source must be connected to a Music Option Module using an RCA
connector in slot X1 (see Figure 4-27 on page 4-32).
● HiPath1130/1150/1190
The audio source must be connected to the MB in slot X8, pins 3 and 4 (see
Figure 4-29 on page 4-34).
4.11 Installing a TFE - Entrance Telephone Interface
4.11.1 Models: S30817-K930-A300 and S30122-K7696-T313
● S30817-K930-A300 (without amplifier)
● S30122-K7696-T313 (with amplifier)
Installation Procedures
4.11.2 Model S30817-Q936-C282 - Brazil
Installation Procedures
This interface can be configured to work in Pager or Entrance Telephone mode.
● Pager Mode
Step Procedure
1. Connect your system to the TFE interface. See“Entrance Telephone In-
terface” on page 3-49.
2. Connect the Entrance Telephone to the TFE interface
3. “Performing a Visual Inspection” on page 4-48.
4. Configure the required data (see “Operation” on page 6-1).
Step Procedure
1. Set jumper 1 (J1) to ON and jumper 2 (J2) to OFF (see“Entrance Tele-
phone Interface” on page 3-49).
2. Configure the system for Entrance Telephone/Door Opener mode and
specify the extensions for answering calls. Specify also at which exten-
sion the interface will be installed.
To Next Page
Loading...
