Siemens HiPath 1130 - Installing a Power Supply

Installation of Expansion and Option Module
s
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
4-29
For internal distribution only Installation
4.6.8 Installing a Power Supply
Introduction
Before connecting the power supply to the system, see “Technical Data” on page 2-
7 “ and “Power Supply Unit (PSU)” on page 3-43.
● On the HiPath 1120
Procedure after Installation
Figure 4-24 Installing a Power Supply HiPath 1120
Step Procedure
1. Check network voltage
2. If the voltage is within the power supply’s voltage range, connect the
power supply.
3. “Performing a Visual Inspection” on page 4-48
4. Configure the required data (see “Operation” on page 6-1).
Warning
To turn the power on or off to the system use the power supply’s cable.
!