Safety Information
Important Information For internal distribution only
A31003-K1250-S100-12-7619
1-6 HiPath 1100, Service Manual
1.1.4 General Information
Line/Cable Connections
● All cables coming out of the system must be protected along their entire path
inside conduits, ducts or other appropriate routes of conveyance.
● Cables must be connected only to their specified connections points.
Location of Safety Equipment
Once maintenance is finished, return all safety equipment to its proper location.
Inspecting your Tools
Inspect tools regularly. Only tools in perfect condition should be used.
Condensation
When moving the equipment from a cold environment to a location at room temper-
ature, take into consideration “Environmental Conditions” on page 2-9 to prevent the
occurrence of condensation. Wait until the equipment is at room temperature and
completely dry before turning it on.
Wall Mounting
● Some types of walls (e.g., drywall) have limited weight-bearing capacity. Before
installing the equipment, check the following:
● Examine the condition of the walls to ensure that there are no cracks or damage
that indicates the presence of humidity.
Flammable Materials
Do not store flammable materials in close proximity to the equipment.
Hazards at the location of operation
● Ensure that the location is well lit.
● There is a higher risk of an accident occurring in or near unorganized premises.
To Next Page
Loading...
