Siemens HiPath 1130 - Table 7-19 ADSL Module

Table of the System’s Programming Codes
Configuring the System Specifically for the Client For internal distribution only
A31003-K1250-S100-12-7619
7-20 HiPath 1100, Service Manual
ADSL Module
Relay and sensor on the HiPath 1120
Ta b l e 7- 1 9 A D S L M o d u l e
Programmed
Functions
Cod
e
Intermediate Data Data to be
Programmed
Completing
Data Entry
Default
Restore ADSL
module default
settings
013 Automatic IP 10.0.0.1
Table 7-20 Relay and sensor on the HiPath 1120
Programmed
Functions
Cod
e
Intermediate Data Data to be
Programmed
Completing
Data Entry
Default
Sensor function
configuration
70 0 = Deactivate the sensor’s
function (default)
1 = Dial the number speci-
fied in "Number Dialed by
Sensor Activation" (Code
052).
2 = Activate the relay
through the sensor
3 = Detect DTMF code.
When this setting is
selected, the number that
was called must acknowl-
edge or ignore an alarm call
by sending an acknowl-
edgement code (“#” DTMF
signal)
Automatic 0
Sensor activation
logic
74 0 - Contacts closed
1 - Contacts open
# instead of the
sensor
0 - Contacts
closed
Time between
Attempts for Acti-
vating the Sensor
050 Time: 00 to 10 minutes Automatic 03 (3 minutes)
MSN Assignment
for the Sensor
051 Slot: 001 to 140 or
∗ − To delete
Automatic None
Number Dialed by
Sensor Activation
052 Number (up to 20 digits) Automatic or
#
None
Number of
Attempts for Acti-
vating the Sensor
053 001 to 100 (attempts) Automatic 001 (1
attempt)
DTMF signals for
the Relay
77 Number (up to 20 digits)
# - To confirm
Automatic None