Siemens HiPath 1130 - Table 7-17 Digital Trunk Settings

Table of the System’s Programming Codes
Configuring the System Specifically for the Client For internal distribution only
A31003-K1250-S100-12-7619
7-18 HiPath 1100, Service Manual
Digital trunk settings
Collect Call Barring 008 1 - Fax
2 - DID
3 - Fax/DID
4 - Message (announcement)
∗ - To enable
# - To disable
# instead of
mode
# - To disable
MSN Answering for
Fax/DID
080 Slot: 001 to 140 0 - Deactivated
1 - Fax
2 - DID
3 - Fax/DID
4 - Message
5 - Autofax
# instead of
slot
00 - Deacti-
vated
Fax Extension for
MSN
081 Slot: 001 to 140 Extension # instead of
slot
None
Fax/DID Release
after a Timeout
094 (00 to 99) in 5-second cycles Automatic 06 (30
seconds)
Table 7-17 Digital trunk settings
Programmed
Functions
Code Intermediate Data Data to be Programmed Completing
Data Entry
Default
S
0
Ports(HiPath
1190
062 Slot: 01 to 20 1 - External line and exten-
sion
2 - External line
3 - Extension
# instead of
slot
1 - External
line and
extension
Mode of Operation
*
90 Slot
+
Physical Interface
1 - Point-to-point connection
(PP)
2 - Point-to-Multipoint
connection (PMP)
3 - S
0 Bus line
# instead of
slot
1 - First port
3 - All other
ports
Symmetric Call 074
∗ - To enable
# - To disable
Automatic ∗ - To enable
Absence of ACK
Setup for external
ISDN Line
075 ∗ - To enable
# - To disable
Automatic # - To disable
Notify 076
∗ - To enable
# - To disable
Automatic ∗ - To enable
Automatic Keypad 077 ∗ - To enable
# - To disable
Automatic # - To disable
Assignment of an
external ISDN line to
a MSN
078 Slot: 001 to 140 external line or
∗ - To delete
# instead of
slot
All assigned
lines
External line prefix 89 1 - National
2 - International
Line prefix (up to 5 digits) # instead of the
digit or Auto-
matic
None
Table 7-16 Fax/DID Module
Programmed
Functions
Code Intermediate Data Data to be Programmed Completing
Data Entry
Default