Siemens HiPath 1130 - Figure 4-6 Hipath 1130;1150 System Installation Overview; Hipath1120;1130;1150 Wall Mounting Instructions

Getting to Know your Systems
Installation For internal distribution only
A31003-K1250-S100-12-7619
4-8 HiPath 1100, Service Manual
Components Location
4.5.3 HiPath1120/1130/1150 Wall Mounting Instructions
Figure 4-6 HiPath 1130/1150 system installation overview
Step Procedure
1. Drill a hole in the wall at a height of 4.10 ft (1.25 m) from the floor.
2. Place the bushing over the hole then insert the screw and tighten it until
only 0.19" (5 mm) protrude.
3. Hang the system at the top of ➀, on the screw (see Figure 4-7 and Figure
4-8).
4. Mark additional holes for washers ➁ and remove the system.
5. Drill the remaining holes as marked, install washers and screws then
tighten them letting 0.19" (5 mm) protrude.
6. Hang the system again and align it by tightening the lower screws.