Siemens HiPath 1130 - Fax;DID Module

Comments about the System’s Programming Code
s
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
7-45
For internal distribution only Configuring the System Specifically for the Client
7.2.11 Fax/DID Module
Provides automatic answering of an external call in addition to message playback and
fax signal detection.
On the HiPath 1120 this module is also responsible for the RTC - Real Time Clock.
This module has three modes of operation: Fax, Attendant and Fax/DID If a S
0
or
TME1 module is installed, a fourth mode of operation is available: Announcement for
a Digital Line.
Call Answering Menu (009)
The Fax/DID module lets you create a customized call answering menu transferring
the call to an extension or a group, depending on the number entered.
Announcement Recording (37)
Allows you to record and playback announcements and messages, transfers and
alarms. Simply speak to record or listen to the playback of a message right after the
end of the sequence.
To stop the recording or playback of an announcement or message press the key “1”.
Call Answering Mode Configuration (27)
The Fax/DID module has five modes of operation available for the different messag-
ing requirements.
Fax Reception Extension (28)
Specifies to which extension a call will be transferred when a fax signal is detected
on an external line.
Collect Call Barring (008)
When collect call barring is activate, all collect calls to a Fax/DID are automatically re-
jected by the system. Call Barring will not work in the case of calls transferred to a
Fax/DID.
MSN Answering for Fax/DID (080)
This setting specifies a Fax/DID answering mode for each MSN number.
If a call has been answered at least once by the system, Collect Call Barring cancels
the blocking.
When an incoming call over a digital line is forwarded for not being answered (*14)
and Collect Call Barring is activated, the call will ring at the first DID for the external
line.