Installing Telephone Terminal
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
4-47
For internal distribution only Installation
Connections
Red wire (R) = voice (extension’s B wire).
Green wire (G) = voice (extension’s A wire).
Black wire (BK) =CD card’s C wire (positive in relation to D).
Yellow wire (Y) =CD card’s D wire (negative in relation to C).
Installation Procedures
Figure 4-34 Connections for telephone jacks (for Brazil)
Step Procedure
1. Install telephone jacks at the extensions.
2. Connect each extension jack to the desired a/b slot on the Main Distribu-
tion Frame.
3. System telephones are preset at factory default for C/D pairs.
If you need to select a different C/D pair, see Figure 4-27 or Figure 4-29
then program the new C/D interface assignment.
4. Install the telephone sets.
5. “Performing a Visual Inspection” on page 4-48.
6. Configure the required data (see “Operation” on page 6-1).
To Next Page
Loading...
