Starting the Programming Mode
Operation For internal distribution only
A31003-K1250-S100-12-7619
6-24 HiPath 1100, Service Manual
For the new settings to take effect you must exit CommServer. When a HiPath 1100
application is activated, the server starts automatically.
Uninstall:
● For the S
0
connection, follow steps 1, 6 and 7 of the procedure.
● For the USB connection, follow steps 1 through 7 of the procedure.
Procedure:
1. To exit CommServer right-click the CommServer icon on the Windows Status bar
and select Finish.
2. Exit all online services for CallBridge for Data
3. Unplug from your computer the USB cable connected to the HiPath 1100 sys-
tem.
4. To remove the USB drivers, proceed as follows:
For FULL removal use Uninstall, or the Uninstall feature on the CD.
5. Uninstall CallBridge for Data Utilities (if previously installed to use online services
or USB connections), by running the Uninstall program as follows:
Start/Programs/CallBridge for Data Utilities/Uninstall CallBridge for Data Utilities.
Once CallBridge for Data Utilities has been uninstalled, answer "No" when asked
if you want to restart your computer, and proceed with step 6.
6. Uninstall all HiPath 1100 components as follows:
Start/Settings/Control Panel/Software, then click on "Remove Software"
7. Next, restart your computer.
The USB drivers are Plug&Play compatible, so that after installation, the HiPath 1100
system may be removed and added again to the computer configuration - by simply
unplugging or connecting the USB cable. The drivers do not need to be reinstalled.
The equipment is ready for operation.
To Next Page
Loading...
