Starting the Programming Mod
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
6-27
For internal distribution only Operation
HiPath 1100 E1 Trunk Manager
The HiPath 1100 E1 Trunk Manager is an administrative program for configuring a
TME1 module.
Hardware Requirements:
– Serial interface communications (COM port).
General Information:
Using the HiPath 1100 E1 Trunk Manager you can:
● Download software and databases
● Select the software’s type of connection to the module (local or via modem)
● Select a COM port
● Select a Country when installing the program, including the appropriate protocol
and CAS signaling (e.g.,line signaling (1bit-E&M and 2bit-R2), and record signal-
ing (DP, DTMF and MFCR2)).
For more details on how to configure a TME1 module refer to the program’s “Help”
system.
Account Manager
Billing Data Software
To launch the Account Manager select:
Start/Programs/HiPath 1100/Call Detail Recording
Status Monitor Indicator
Status Monitor Indicator on the computer.
To start a Status Monitor Indicator, select:
Start/Programs/HiPath 1100/StatusMonitor
If the module does not initialize, check its status on the 7-segment display (see
“TME1 Module” on page 3-27).
Availability of the HiPath 1100 Manager, HiPath 1100 ADSL Manager and HiPath
1100 E1 Trunk Manager administration software is subject to the client’s completion
of the technical course for users of the equipment.
To Next Page
Loading...
