Siemens HiPath 1130 - Page 250

Index For internal distribution only
A31003-K1250-S100-12-7619
10-2 Service Manual
Modules 3-1
Overview 3-1
Motherboard (MB) 3-8
HiPath 1120 3-8
HiPath 1130/1150 3-12
O
Option Module (MO)
TME1 module 3-27
Option Modules (MO) 3-25
CD 16 module 3-40
S0 module 3-25
Option modules (MO)
ADSL module 3-34
Fax/DID module 3-38
Option Modules(MO) HiPath 1120
Music module 3-41
P
Performing a Visual Inspection 4-48
Power Supply Unit (PSU) 3-43
Power Systems 2-1
Powering/Protecting the System 4-42
Profiset 3005, Profiset 3010 and Profiset
3025 Telephone Sets. 5-10
Profiset 3030 System Telephone 5-4
Programming
Digital trunk 7-18
Programming an Extension 7-6, 7-27
Programming Comments 7-21
Programming Mode 6-2
Programming Mode Syntax 6-2
Programming with a computer 6-3
Protection of External Lines and Extensions
4-43
Protective Power Outage Relays 4-45
PSU specifications
HiPath 1120 3-43
HiPath 1130/1150/1190 3-45
R
Relay and Sensor configuration on the HiPath
1120 7-20
Remote Administration 7-13
Run quick test 7-21
S
Safety Information 1-1
caution 1-5
warning 1-4
Safety information
danger 1-3
Safety Symbols 1-1
Select the location for installing the equip-
ment 4-4
Size of the HiPath 1120 system 4-5
System Cabling 4-46
System Data 2-1
System Telephone Feature Keys 5-8
System Telephone Settings 5-8
System Telephones 5-1
T
Table of the System’s Programming Codes
7-1
Technical Standards and Compliance 2-9
Telephones 5-1
TFE Entrance Telephone Interface 3-49
The E805 S e E805 C Telephones 5-14
TME1 Coax Cable 3-56
TME1 Module Connector Assignments 3-29
TME1 Serial Cable 3-55
U
Unpacking System Components 4-4
Updating the Software 6-1, 7-13
USB adapter cable 3-54
Using a Telephone Set 6-2
V
V.24 Adapter Cable 3-52
Voice Mail 7-11
W
What to do in Case of an Emergency 1-7