Siemens PFA-100 System - Page 136

PFA-100 System – Instruction Manual (US) – Version 1.0.1
4IX
Index
setup patient identification request 7-7
test with PID 8-4
test without PID 8-6
patient results 6-9, 7-9
printing 8-10
see also test results
PID 12-11
pin assignment 6-11
see also interface
platelet dysfunction 2-1
excess of maximum time 12-6, 12-10
hematocrit 12-9, 12-10
insufficient sample 12-9
principle of analysis 6-12
power
maximum current 6-7
power consumption 6-7
power cord 3-6, 3-13
power supply 3-10
power switch 3-15, 4-1, 4-4, 6-10, 10-2
switch off 4-4
switch on 4-1
previous trigger prime cancelled 12-11
priming cartridge 3-6, 7-1
see also ordering information
printer 6-4
failure 12-11
paper 3-16
paper roll 3-7, 3-14, 11-13
paper roll axle 3-5, 3-14
printhead 3-15, 11-13
ribbon 3-6, 11-14, 11-15
type 6-9
protective equipment
gloves 4-2, 11-6
R
RAM memory error 12-12
range of application
see intended use
range of values
see reference range
reference range 7-9
see also status messages
repair service
see Siemens service
results
see test results
S
safety standards 2-7
instructions 2-2
sample 4-2
collection 8-1
duplicates 8-2, 8-4, 8-7
insertion into PFA test cartridge 8-3
insufficient sample 12-9
low sample viscosity 12-9, 12-10
maximum sample volume 6-8
quality control sample 9-1
self diagnostics 12-1
self test 2-6, 4-1, 9-1, 11-7, 12-1
Siemens service 5-1
single test 8-4
see also tests
softkeys
see keys