Siemens SIMOCODE pro - Page 207

Tables, data records
3.4 Tables, PROFINET data records
SIMOCODE pro - Communication
Function Manual, 11/2018, A5E40508495002A/RS-AC/003
207
Node ID
Data type
Description
GG3
GG3 GP
212
Boolean
Event - Parameter blocking during start-up active
✓
✓
213 Boolean Event - Parameter changes not allowed in the
current operating state
✓ ✓
214 Boolean Event - Device does not support the required
functions
✓ ✓
215
Boolean
Event - Wrong parameter
✓
✓
216
Boolean
Event - Wrong password
✓
✓
217
Boolean
Event - Password protection active
✓
✓
218
Boolean
Event - Factory settings
✓
✓
219
Boolean
Event - Parameter setting active
✓
✓
220
Unsigned byte
Event - Prm error number
✓
✓
228
Boolean
Event - DM-F LOCAL configuration mode
✓
—
229 Boolean Event - DM-F LOCAL - actual configuration and
desired configuration different
✓ —
230
Boolean
Event - DM-F LOCAL waiting for start-up test
✓
—
231 Boolean Event - DM-F incorrect PROFIsafe address or
incorrect PROFIsafe parameter
✓ —
232 Boolean Event -
Initialization Module write protected, parameter
changes not allowed
✓ ✓
233 Boolean Event - Memory module write-protected ✓ ✓
234
Boolean
Event - Initialization module write-protected
✓
✓
235 Boolean Event - Initialization module identification data
write-protected
✓ ✓
Diagnostic warnings (1)
236
Boolean
Warning - Prewarning overload (I>115%Is)
✓
✓
237
Boolean
Warning - Unbalance
✓
✓
238
Boolean
Warning - Overload
✓
✓
239
Boolean
Warning - Overload + loss of phase
✓
✓
240
Boolean
Warning - Internal ground fault
✓
✓
241
Boolean
Warning - External ground fault
✓
✓
243
Boolean
Warning - Thermistor trip level
✓
✓
244
Boolean
Warning - Thermistor short circuit
✓
✓
245
Boolean
Warning - Thermistor open circuit
✓
✓