Communication
2.2 PROFINET communication
SIMOCODE pro - Communication
90 Function Manual, 11/2018, A5E40508495002A/RS-AC/003
Figure 2-29 Representation in the object directory of the SIMOCODE pro V PN-OPC UA server
(see also table below)
Configuration of OPC UA Send in SIMOCODE ES
Representation in the object directory of the
SIMOCODE pro V PN-OPC UA server
OPC UA Send - Bit 0.0: "Status ON<" Acyclic Send → Status - On <
OPC UA Send - Bit 0.1: "Status Off"
Acyclic Send → Status - Off
OPC UA Send - Bit 0.2: "Status ON>"
Acyclic Send → Status - On >
OPC UA Send - Bit 0.3: "Not connected"
Acyclic Send → Not connected
OPC UA Send - Bit 1.7: "Not connected"
Acyclic Send → Status - On <
Note
Restarting the communication interface
Each change to the configuration of the OPC
UA send data requires that the communication
A new start of the communication interface interrupts all Ethernet and PRO
FINET links and
reestablishes them afterward.
To Next Page
Loading...
