Setting the bus address
Procedure
1. Set the address using one of the subsequently listed options:
– Via the address switch
– With a commissioning tool via p0918
2. Switch o the converter power supply.
3. Wait until all LEDs on the converter are dark.
4. Switch on the converter power supply again.
Your settings become eective after switching on.
The PROFIBUS address is set.
❒
Installing
4.10Connecting the interfaces for the converter control
SINAMICS G120C Converters
116 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK
To Next Page
Loading...
