Increasing the drive availability
The kinetic buering converts the kinetic energy of the load into electrical energy to buer
short-term power failures.
Kinetic buering (Vdc min control) (Page350)
The "Flying restart" function permits the fault-free switching on of the motor while it is still
turning.
Flying restart – switching on while the motor is running (Page346)
For active automatic restart, after a power failure, the converter attempts to automatically
restart the motor and to acknowledge any faults that occur.
Automatic restart (Page348)
Energy saving
For standard induction motors, the eciency optimization reduces the motor losses in the
partial load range.
Eciency optimization (Page352)
If necessary, the main contactor control disconnects the converter from the power system
and so reduces the converter losses.
Line contactor control (Page355)
The converter calculates how much energy controlled converter operation saves when
compared to mechanical ow control (e.g. throttle).
Calculating the energy saving for uid ow machines (Page357)
8.2 Brief description of the parameters
Overview
The brief parameter description provides the most important information for all of the
parameters that are assigned to a certain converter function.
If the number of parameter indices depends on the data sets, then the parameter index is
shown in an abbreviated form.
1XPEHURILQGLFHV QXPEHURIPRWRUGDWDVHWV0'6
3DUDPHWHUVZLWKLQGLFHV
3DUDPHWHUVZLWKELWV
1XPEHURILQGLFHV QXPEHURIGULYHGDWDVHWV''6
1XPEHURILQGLFHV QXPEHURIFRPPDQGGDWDVHWV&'6
1XPEHU1DPH)DFWRU\VHWWLQJ
S>&@
S>'@
S>0@
S>@
S
Figure8-1 Brief parameter description
Advanced commissioning
8.2Brief description of the parameters
SINAMICS G120C Converters
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK 185