Siemens SINAMICS G120C DP

5.6.2 Restore the factory settings (without safety functions)
Resetting to factory settings with Startdrive
Procedure





1. Go online.
2. Select "Commissioning".
3. Select "Back up/reset".
4. Select "All parameters will be reset".
5. Press the "Start" button.
6. Wait until the converter has been reset to the factory settings.
You have reset the converter to the factory settings.
❒
Resetting to factory setting with the BOP-2 operator panel
Procedure
1. Select "Reset to factory settings"
2.2.
2. Start the reset.
2.
3. Wait until the converter has been reset to the factory setting.
2.
You have reset the converter to the factory settings.
❒
Commissioning
5.6Restoring the factory setting
SINAMICS G120C Converters
156 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK