Siemens SINAMICS G120C DP

Function description
The following free function blocks are available:
Table 8-37 Free function blocks
Logic blocks AND0
AND1
AND2
AND3
OR0
OR1
OR2
OR3
XOR0
XOR1
XOR2
XOR3
NOT0
NOT1
NOT2
NOT3
NOT4
NOT5
Calculation
blocks
Adder Subtractor Multiplier Divider Compara‐
tor
Absolute
value
Polyline
ADD0
ADD1
ADD2
SUB0
SUB1
MUL0
MUL1
DIV0
DIV1
NCM0
NCM1
AVA0
AVA1
PLI0
PLI1
Timer blocks Pulse gen‐
erator
Pulse
shorten‐
ing
ON delay OFF delay Pulse stretching
MFP0
MFP1
MFP2
MFP3
PCL0
PCL1
PDE0
PDE1
PDE2
PDE3
PDF0
PDF1
PDF2
PDF3
PST0
PST1
Memory block RS 󹪞ip-󹪞op D 󹪞ip-󹪞op
RSR0
RSR1
RSR2
DFR0
DFR1
DFR2
Breaker block Analog
switch
Binary switch
NSW0
NSW1
BSW0
BSW1
Control block Limiter Smooth‐
ing
Integrator Di󹪜erentiator
LIM0
LIM1
PT10
PT11
INT0 DIF0
Complex block Limit monitor
LVM0
LVM1
You can only use a function block once. The converter has 3 adders for instance, ADD0,
ADD1, and ADD2. If you have already con󹪝gured 3 adders, then no other adders are
available.
Application description for the free function blocks
Further information is provided on the Internet:
FAQ (http://support.automation.siemens.com/WW/view/en/85168215)
Advanced commissioning
8.14Free function blocks
SINAMICS G120C Converters
250 Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK