Siemens SINAMICS G120C DP

5.4.6 Expert.............................................................................................................................. 133
5.4.7 Identifying the motor data and optimizing the closed-loop control.................................... 137
5.5 Quick commissioning with a PC........................................................................................ 138
5.5.1 Creating a project ............................................................................................................ 138
5.5.2 Transfer converters connected via USB into the project ..................................................... 139
5.5.3 Go online and start the commissioning Wizard ................................................................. 140
5.5.4 Overview of quick commissioning .................................................................................... 141
5.5.5 Commissioning wizard..................................................................................................... 142
5.5.6 Standard Drive Control..................................................................................................... 144
5.5.7 Dynamic Drive Control ..................................................................................................... 146
5.5.8 Expert.............................................................................................................................. 148
5.5.9 Identify motor data .......................................................................................................... 151
5.6 Restoring the factory setting ............................................................................................ 153
5.6.1 Resetting the safety functions to the factory setting.......................................................... 154
5.6.2 Restore the factory settings (without safety functions)...................................................... 156
5.7 Series commissioning ...................................................................................................... 157
5.8 Handling the BOP 2 operator panel................................................................................... 158
5.8.1 Menu structure, symbols and keys.................................................................................... 158
5.8.2 Switching the motor on and o󹪜 ........................................................................................ 159
5.8.3 Changing parameter values.............................................................................................. 160
5.8.4 Changing indexed parameters.......................................................................................... 161
5.8.5 Entering the parameter number directly ........................................................................... 162
5.8.6 Entering the parameter value directly............................................................................... 163
5.8.7 Why can a parameter value not be changed? .................................................................... 164
6 Uploading the converter settings ...................................................................................................... 165
6.1 Why does an upload make sense?..................................................................................... 165
6.2 Uploading to the memory card......................................................................................... 165
6.2.1 Recommended memory cards.......................................................................................... 165
6.2.2 Automatic upload ............................................................................................................ 166
6.2.3 Message for a memory card that is not inserted................................................................ 168
6.2.4 Manual upload with Startdrive ......................................................................................... 168
6.2.5 Manual upload with BOP-2............................................................................................... 169
6.2.6 Safely removing a memory card using the BOP-2 .............................................................. 170
6.2.7 Safely remove the memory card with Startdrive................................................................ 171
6.3 Uploading to the BOP-2.................................................................................................... 172
6.4 Upload to a PC using Startdrive ........................................................................................ 173
6.5 More options for the upload............................................................................................. 173
7 Protecting the converter settings ...................................................................................................... 175
7.1 Write protection............................................................................................................... 175
7.2 Know-how protection ...................................................................................................... 176
7.2.1 Extending the exception list for know-how protection ...................................................... 180
7.2.2 Activating and deactivating know-how protection ............................................................ 181
8 Advanced commissioning.................................................................................................................. 183
8.1 Overview of the converter functions................................................................................. 183
Table of contents
SINAMICS G120C Converters
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK 7