Siemens SINAMICS S120 Combi - Page 103

S120 Combi Power Modules
4.7 Installation
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
103
Screws to be used
:
M4 x 10 (ISO 7045 (DIN 7965), ISO 7380, DIN EN ISO 1207, ISO 1580M4)
Tightening torques
:
Initially tighten by hand (0.5 Nm), then tighten with 1.8 Nm
Installing the reinforcement plates
Insert the left reinforcement plate into the
mounting cut-out.
Locate the reinforcement plate on the
mounting panel.
Screw the reinforcement plate at the top and
bottom.
Insert the right reinforcement plate into the
mounting cut-out.