Siemens SINAMICS S120 Combi - Meaning of the Leds; Meaning of Leds on the Sensor Module Cabinet-Mounted SMC30

Encoder system connection
10.2 Sensor Module Cabinet-Mounted SMC30
254
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
10.2.3
Meaning of the LEDs
10.2.3.1
Meaning of LEDs on the Sensor Module Cabinet-Mounted SMC30
Table 10- 10 Meaning of LEDs on the Sensor Module Cabinet SMC30
LED
Color
Status
Description, cause
Remedy
RDY
READY
– Off The electronics power supply is missing or outside the per-
missible tolerance range.
–
Green Continu-
ous light
The component is ready for operation. Cyclic DRIVE-CLiQ
communication is taking place.
–
Orange Continu-
ous light
DRIVE-CLiQ communication is being established. –
Red Continu-
ous light
This component has at least one fault.
Note:
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Remedy and
acknowledge fault
Green /
Red
0.5 Hz
flashing
light
Firmware is being downloaded. –
Green /
Red
2 Hz
flashing
light
Firmware download is complete. Wait for POWER ON. Carry out a POWER
ON
Green /
Orange
or
Red /
Orange
Flashing
light
Component recognition via LED is activated. This function is
parameterizable (see SINAMICS S120/S150 List Manual).
Note:
Both options depend on the LED status when component
recognition is activated.
–
OUT > 5
V
– Off Electronic power supply is missing or outside permissible
tolerance range.
Power supply ≤ 5 V.
–
Orange Continu-
ous light
Electronics power supply for encoder system available.
Power supply > 5 V.
Notice
Make sure that the connected encoder can be operated with
a 24
V power supply. If an encoder that is designed for a 5 V
supply is operated with a 24 V supply, this can destroy the
encoder electronics.
–