Siemens SINAMICS S120 Combi - Encoder system connection; Sensor Module Cabinet-Mounted SMC20

Additional system components
9.2 DRIVE-CLiQ Hub Module DMC20
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
225
9.2.3.2
X524 Electronics power supply
Table 9- 16 Terminals for the electronics power supply
Terminal
Designation
Technical data
+
Electronics power supply
Voltage: 24 V DC (20.4 ... 28.8 V)
Current consumption: max. 0.5 A
Max. current via jumper in connector: 20 A (15 A ac-
cording to UL/CSA)
Type: Screw terminal 3 (Page 307)
Max. connectable cross-section: 2.5 mm
2
Tightening torque: 0.4 … 0.5 Nm
+
Electronics power supply
M
Electronics ground
M Electronics ground
The maximum cable length that can be connected is 10 m.
Note
The two "+" and "M" terminals are jumper
ed in the connector. This ensures that the supply
voltage is looped through.
The current consumption increases by the value for the DRIVE
-CLiQ participants.
9.2.3.3
X500-X505 DRIVE-CLiQ interfaces
Table 9- 17 X500-X505: DRIVE-CLiQ interfaces
Pin
Signal name
Technical data
1
TXP
Transmit data +
2
TXN
Transmit data -
3
RXP
Receive data +
4
Reserved, do not use
5
Reserved, do not use
6
RXN
Receive data -
7 Reserved, do not use
8
Reserved, do not use
A + (24 V) Power supply
B
M (0 V)
Electronics ground
Connector
type
DRIVE-CLiQ socket
The blanking covers for the DRIVE
-CLiQ interfaces are included in the scope of delivery.
Blanking covers (50 x) Article No.: 6SL3066-4CA00-0AA0