Siemens SINAMICS S120 Combi - Signal Cables at the EP Terminals

S120 Combi Power Modules
4.8 Electrical connection
118
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
4.8.4
Signal cables at the EP terminals
The shields of the signal cables connected to the EP terminals X21 and X22 are connected
using the shield clamp
① from the accessories pack (Weidmüller: KLBÜ 4-13.5). The
connection involves the following steps:
● Secure the shield connection clamp on the S120 Combi. Use an SW3 wrench with 1.8
Nm tightening torque.
● Remove the insulation from the signal cables and crimp the individual cores with
end
s
leeves.
● Connect the cable cores to the EP terminals (screw terminals).
● Connect the cable shields as shown below.
Figure 4-27 Signal cables connected with the correct shield support